legacy powermaster

Brian,

Did you switch the program run switch to run. After doing this you need to press TR plus the number you programmed it for, than I just dial up the throttle

Ray. 

You did not mention if your Powermaster is TMCC or Legacy. If it is the Legacy you also need the Command base.

I'll try it again but sure I did that.is there away to clear and start over.
Brian
On Oct 28, 2014 8:12 AM, "O Gauge Railroading On Line Forum" <alerts@hoop.la>
wrote:

If you have a standard PowerMaster and not the Legacy model, it is not compatible with the Legacy system without the additional Legacy PowerMaster Bridge.

I have legacy powermaster.
On Oct 28, 2014 10:06 AM, "O Gauge Railroading On Line Forum" <
alerts@hoop.la> wrote:

Press TR ID #, press Boost.

i'll try that thanks.

On Tue, Oct 28, 2014 at 8:12 AM, O Gauge Railroading On Line Forum <
alerts@hoop.la> wrote:

Assuming you have the ID programmed and selected, you can power up using the following:

 

1. turn the throtle knob (variable for conventional)
2. press AUX1 and then 9 (full power 18 volts for command )
3. press AUX1 and then 8 (30% PoweR)
4. Press boost

Technically, if your using the CAB 2 Legacy system you want to "roll up" the boost/ brake "multi function control."

thank you will try that.

On Tue, Oct 28, 2014 at 8:16 PM, O Gauge Railroading On Line Forum <
alerts@hoop.la> wrote: