Hello, I purchased a 1999 Lionel 6-28005 E-6 4-4-2 O-Scale Atlantic recently. The Rail-Sounds and the smoke unit do not work. Is there replacement parts for this 4-4-2 locomotive?
Thank you,
John
Original Post
Replies sorted oldest to newest
If you are running conventional neither will work properly due to the low voltage that is needed to run the engine. It works best in command control with constant 18volts.
Romiller
Romiller
romiller49 is correct. Your engine shows signalsounds. That is a 24 pin board located in the tender. I would pull the board and plug it back in. If that does not work, you may need a replacement.
For the smoke, look for a broken wire at the on/off switch. That is a puffer unit. Check the out ent of the smoke heater to be sure it has not broken off the solder joint to ground.
Did you buy the locomotive knowing these issues existed?
Thank you, sir, I will give it a try.
On Tuesday, March 17, 2015 2:06 PM, O Gauge Railroading On Line Forum <alerts@hoop.la> wrote:
Reply By Marty Fitzhenry: Lionel 6-28005 E-6 4-4-2== To reply by email, write above this line. == Hello, AFL O&S Gauger: We're sending you this notification because you are either following the forum, the content, or the author listed below. New Reply To Topic
| Subject: Lionel 6-28005 E-6 4-4-2 Reply By: Marty Fitzhenry In: Train Forums / Hi-Rail, O27 and Traditional 3-Rail O Gauge | |
romiller49 is correct. Your engine shows signalsounds. That is a 24 pin board located in the tender. I would pull the board and plug it back in. If that does not work, you may need a replacement. For the smoke, look for a broken wire at the on/off switch. That is a puffer unit. Check the out ent of the smoke heater to be sure it has not broken off the solder joint to ground. View This Reply
| | Unlock Your OGR Digital Subscription Just $29.95 Per 12 Months |
Sincerely, O Gauge Railroading On Line Forum https://ogrforum.ogaugerr.com To adjust your email notifications for this site, please update your notification settings. To suspend ALL email notifications from this site, click here. Powered By Hoop.la
On Tuesday, March 17, 2015 2:06 PM, O Gauge Railroading On Line Forum <alerts@hoop.la> wrote:
Reply By Marty Fitzhenry: Lionel 6-28005 E-6 4-4-2== To reply by email, write above this line. == Hello, AFL O&S Gauger: We're sending you this notification because you are either following the forum, the content, or the author listed below. New Reply To Topic
| Subject: Lionel 6-28005 E-6 4-4-2 Reply By: Marty Fitzhenry In: Train Forums / Hi-Rail, O27 and Traditional 3-Rail O Gauge | |
romiller49 is correct. Your engine shows signalsounds. That is a 24 pin board located in the tender. I would pull the board and plug it back in. If that does not work, you may need a replacement. For the smoke, look for a broken wire at the on/off switch. That is a puffer unit. Check the out ent of the smoke heater to be sure it has not broken off the solder joint to ground. View This Reply
| | Unlock Your OGR Digital Subscription Just $29.95 Per 12 Months |
Sincerely, O Gauge Railroading On Line Forum https://ogrforum.ogaugerr.com To adjust your email notifications for this site, please update your notification settings. To suspend ALL email notifications from this site, click here. Powered By Hoop.la
Thank you gentlemen. I will give it a try.
