Skip to main content

Still learning the DCS side of my layout.

I have been only using the two fixed channels of my Rev L (Ver 6.0) TIU and not the variable channels.  Today I set up my yard tracks on the Var 2 channel (first time it has been used), set to On and Fixed, using it in passive mode.  I get no signal from that channel.  I switched the wires around, and the other three channels work fine getting the signal to the yard.  I put a second TIU in and all channels work.

I'm not sure where the signal generator is connected to the wiring.  If it is before the fuse, then I would hope it is a fuse issue.  If it is after the fuse, then it may be the generator.

I'm trying to decide if it is something I can try to fix or just send it to someone to fix it.  Any recommendations?

Original Post

Replies sorted oldest to newest

Add Reply

Post
The DCS Forum is sponsored by
OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
Link copied to your clipboard.
×
×