I looked to see if MTH has specification for minimum curve Radius for each of these PS3 wireless drawbars of 30mm, 35mm and 50mm; however, I could not find any information on curve radius. Does anyone know what are the minimums for the curve radius for theses wireless drawbars?
I was wondering if 30mm will work with O60 curves?
Ken
Replies sorted oldest to newest
I used 40mm on O42 with no problems so you should have no problems. Even though MTH states 40mm is for O54 and above but it works on O42 without any problems.
Beings I run railking the distance between engine and tender is too big that's why I use another wireless drawbar to close that gap.
I think the only way to know is to try them. The location of the connectors on the engine and tender vary from engine to engine. Its the final coupling distance that will determine how tight a curve you can run them on.
Pete
Access to this requires an OGR Forum Supporting Membership
