Does anybody know how to install a potentiometer for the sound volume. The instructions say to contact TAS for proper removal of two resistors. Well it's a little too late for that. I can adjust the volume with the cab 1 but prefer to use the potentiometer as a master.
Rod Miller
Replies sorted oldest to newest
Is this an EOB board? I'm confused about those instructions as I just plug a pot into this connector. Sometimes you'll see two of these with a jumper soldered across them.
I tried calling the number in the documentation, but it was disconnected. 
Don't you have to remove two resistors if installed, or was that just for the early boards?
Good question, I've never removed any resistors and the volume control has always worked.
Yes it is an EOB board. I'll try just plugging the potentiometer in and ignore the resistors and see what happens. Ill get back with results.
Rod Miller
Access to this requires an OGR Forum Supporting Membership
