wiring #57, #6924 and #6098

Try this page, it has all of Atlas' wiring diagrams for their different parts. 

Atlas Diagrams

Hi, rtr12 and thanks. I looked at the Atlas site but I did not find a specific diagram.  One diagrams shows wiring the under table machine so the controller lights follow.  I'm not concerned about the controller lights following. So ..................

Could I wire the #6098 following the basic instructions using the #56 controller and the #6924?

This diagram from the Atlas website should work.

Same diagram from the link above.

Thanks. This is what I had in mind. The only difference I see is the location of the ground/common to a center post of the #6098s compared to the center end location shown above, yes?

The 6098 under table machine has a similar momentary power design.  There should be a diagram with this machine.    The (3) screws at the left end in this picture are used for switch motor power (Momentary Power ONLY).  The (6) screws (Middle sides of the switch in the picture) are (2) sets of NC/Common/NO contacts used for indication signals or power routing if required.

Yes, Mike and thanks to all for the input. I understand I can wire in a simple manner because I am not going to power the frogs, nor am I worrying about the controller lights following the switch direction because I will rely on dwarf signals to show switch direction.

My control panel is not the center of attention because I run the switches through my AIU's.

Again thanks for the input,   but keeping fingers crossed wouldn't be a bad idea though.

This diagram shows wiring to an AIU in addition to a # 56 switch, I'm not sure there is a diagram that shows both the AIU and #57 switch. I will continue to look.   The #57 switch was a late entry.
The diagram also shows connection of the Atlas 6931 Dwarf light signal to the switch motor. These dwarf indicators can be finicky, depending on the impedance of the snap coils.
 
Most of mine works, some don't. I was told Atlas would replace the switch motors of the ones that don't.   I'm not sure how the 6931 dwarf lights will work with the 6098 switch motors, check with Atlas.
Best wishes with your project
Mike CT

One would think Atlas would have come out with a #57 wiring diagram for the application we have been discussing. The #57 has been out for a while now.

I'll  be holding my breath when I power up the first time.

I saw Ericstrains videos - two parts which descirbe hooking up 57.  About 25 mins into part 1 gives a detail installation of 57.  Both videos are very helpful.  see link to Youtube:

www.youtube.com/watch?v=Y31p1AiPaWA

If you wire your 6098 switch motor in place of the motor included with the switch it will not work. The dwarf signal control board was designed to work with the switch motor that came with the switch.