Skip to main content

Picked up an Atlas undec GP9.

All the bits and pieces need to be installed - no problem.

atlasgp9

Included was a bag of 14 of little black squares with a milled out area (left).  Jig to install the lifting eyes?  Also the hammer looking thing, any ideas?  The horizontal metal part will slide in the plastic holder.

Nothing in the box explaining what these items are.

Attachments

Images (1)
  • atlasgp9
Original Post

Replies sorted oldest to newest

Is it a powered unit with a QSI decoder? If it is then that is the "magic wand" used to reset the decoder in the event that it becomes unresponsive to DCC commands.

To reset an engine, power the track with about 10V DC and hold the "wand" an inch or two above the reed switch which is usually located near the smokestack. I think there is a verbal message that indicates that the decoder has been reset.

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×