Skip to main content

Wanted to try my hand at making a plate girder bridge (which are quite common around here). Since I'm printing with resin, build space is limited (and while I could print longer pieces vertically, the trade off in build time usually isn't worth it, unless I absolutely, positively have to).

Went with a modular design, so I could go as long as I want (as wide too if I modify it slightly). Along the way I learned a good bit about the construction of plate girder bridges (and the current design will be further modified, but wanted to finish what I started first.

This one has 3 sections and endcaps. Simple boards between sides, which in later versions will be I beams with boards on top (so the ballast doesn't fall down to the street). Total print time for the entire thing was about 16 hours, and maybe $10 worth of resin.

20210307_204901

Attachments

Images (1)
  • 20210307_204901
Original Post

Replies sorted oldest to newest

@BillYo414 posted:

That looks amazing!! What did you use for assembly?

I used JB Kwickweld to assemble the side pieces, using little sewing clips to hold them together while they set. I just attached the base pieces with generic crazy glue, but I'll be supplementing that with something else, as it doesn't seem strong enough. Would have used model glue, but I have no idea how well it works on cured resin.

@Magicland posted:

Would have used model glue, but I have no idea how well it works on cured resin.

That's a good point. I print FDM PLA and I never considered using model glue. I wonder how it would work!

Thanks for the glue selection info though. I've been using Loctite Go2 and it's ok. I mostly like it because it's easy to cut any flashing off the joint where the glue is. The bridge looks great! It's pretty cool that it's functional as well.

Add Reply

Post
OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
Link copied to your clipboard.
×
×