E-UNIT TROUBLES

There is a circuit error somewhere if forward runs OK, like a grounded brush.

@ADCX Rob posted:

There is a circuit error somewhere if forward runs OK, like a grounded brush.

Thank you for the reply on one side of the E Unit switch the wire is as indicated. on the side that is labeled ground where should that wire go I have it as an empty post. Thanks again

@Jolodo posted:

Thank you for the reply on one side of the E Unit switch the wire is as indicated. on the side that is labeled ground where should that wire go I have it as an empty post. Thanks again

That lever is riveted to the frame of the E-Unit, which is affixed to the parallel plates of the motor - chassis ground - and as such is common to the field laminations and bulb grounds.

Thanks for your info... I will recheck for a possible grounding issue.

@Jolodo posted:

Thanks for your info... I will recheck for a possible grounding issue.

The ground on that lever only completes the circuit for the solenoid, which by your description is working OK, so the problem is on the left side of the circuit.

Thanks Rob... I will trace back on left side of circuit.