Hi Everyone,
Somewhat new (a few posts regarding Lionel TMCC/Legacy vs conventional) to this forum, and I have NEVER before used a commercially produced wheel puller (having hammered out the axle on a TMCC 746's drive wheels with a nail set and the open jaws of a vise), but my first try of Frank Timko's wheel puller was absolutely FANTASTIC! I scribed the axle/wheels so I could later quarter them properly, set the center push pin on the axle, snugged the outside "pullers" up on the bind/flanged drive wheel, and in less than 10 minues had pulled the rear drive wheels and the blind wheels next to it off.
Thanks, Frank Timko !!!