Skip to main content

Closed12 replies

LCRU and ERR Sound Commander Problem

modeltrainspartsmodeltrainspartsOGR Forum Member
I posted this question in the discussion of "Can I use an LCRU2 to Run a DC Motor", but on second thought fell it should be a separate question.

I've been using Carl's (See above referenced post) wiring diagram to run DC motors with a LCRU for close to 10 years now.
Suddenly i've run into a problem: i've added an ERR Sound Commander to the circuit in two identical locos (GG1's) and have developed a problem in only ONE of them. In one installation everything works (start-up sounds, horn, bell; directional lighting; and engine runs perfectly). However in the second installation with the Sound Commander connected i get ONLY start-up sounds (NO horn or bell) and the engine will NOT move NOR change directional lighting -- disconnect the Sound Commander and the engine runs as it should.
Any ideas before i call ERR tomorrow??
jack
Original Post

Replies sorted oldest to newest

G GGGOGR Forum Member
Did the second ERR unit ever work? Can you swap the ERR units into the other units. If the problem follows the ERR, I would suspect an ERR board problem, if the original offending GG still won't work with the other ERR board, and the working one still works, then I would suspect something amiss on the GG1 LCRU. G
gunrunnerjohngunrunnerjohnOGR Forum Member SUPPORTING MEMBERDIGITAL SUBSCRIBER
First, I'd swap the boards and see if it follows the board.

FWIW, I had an ERR Cruise Commander and I tried to use a different RailSounds package with it and it also interfered. This was the Lionel two board set with a small motherboard that works fine connected to a Mini-Commander equipped engine, don't know what about the Cruise Commander and this board was the issue. I suspected interference from the switching power supply board.
G GGGOGR Forum Member
quote:
Originally posted by modeltrainsparts:
That would be OK except i need to do three (3) GG1's and as of now only one works correctly. Short of finding a solution to the LCRU problem, the answer will be to either use ERR DC Commanders, or (if i have any left in inventory) DD DC Deluxes instead of the LCRUs.


Why not 2? Use the appropriate LCRU and Sound Commander that work together to get 2 good units. Otherwise I can't explain the incompatibility. G
Views: 1,285
Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

Membership Required

We're sorry. You must be signed in to continue. Sign In or Register
×
Are you sure you want to remove from your Block List?
×
Loading...
×
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
×
Link copied to your clipboard.
×

Access to this requires an OGR Forum Supporting Membership

OGR Forum Supporting Membership

Help support this forum with an OGR Forum Supporting Membership.
You will be able to watch the videos in the INSTRUCTIONAL VIDEO FORUM!
A one-year OGR Forum Supporting Membership is only $12 per year, so sign up now!


    OR     


Access the ALL the OGR VIDEO FORUMS AND  over 300 back issues of OGR
with a DIGITAL SUBSCRIPTION!



$12.00 per 12 Months (plus tax if applicable)
×