Skip to main content

Is this tender backup PS2 5Volt board backup light harness still available from MTH or anyone else in need of the part number if so. It is the one near bottom of below diagram and goes into the 12 pin board assembly  that says PS-2 tender backup light and with purple wire also going into the proto coupler harness. Need the complete harness with the 2 plug ends one for backup light with the proto coupler harness plug end attached to it  and also need the led light harness that plugs into the green plug shown in picture with led light on the other end.

It is my hope to get it back to the way it was with back up light and proto coupler back working.

In doing a search found this diagram posted by GUNRUNNERJOHN hope John does not mind .

PS2%20Tender%20Wiring john

Last edited by Dieseler
Original Post

Replies sorted oldest to newest

My Mth engine number is 30-1224-1 from year 2002 . The tender had a reverse light  just like the 30-1224-1 picture on Mth website when i typed in the number in the search function.

If its any help tender also houses 5volt board and battery.

The tender has outside dummy plastic red marker lights on outside the inside behind marker lights is solid so they never did light up  . Backup light is in middle of tender and when no longer worked i opened tender shell and it appeared to be a minature bulb that looked like a led but could be wrong as it is long gone now it went through a small hole in metal bracket . I could not open the connector so unplugged the harness from board and since lost it and the reverse light with its plug end.

Would like to put it back to way it was originally if the parts are available.

Toward bottom of picture below i crudely circled the dual connected wire harness needed.

Its for the reverse light and the proto coupler.

and

also needed is the backup light with its harness and connector if available .

Thanks

PS2%20Tender%20Wiring john

HPIM1074 [Medium)

 

 

HPIM1069 [Medium)

Attachments

Images (2)
  • PS2%20Tender%20Wiring john
  • HPIM1074 (Medium)
Last edited by Dieseler

So you have the 12 pin connector and you have the 10 pin external harness to connect to engine, you just need a wire set that has the green backup light and black coupler connector with the wires to plug back into the 12 pin??  The backup light is a 6V Grain of wheat with 2 pin molex.  I have what you need, just need to be sure what your after.  The full harness has the 12 pin, 4 pin smoke, 5 pin motor, and 7 pin power all in one assembly.   G

GG - Yes  as you said needed is wire set that has the green backup light and black coupler connector with the wires to plug back into the 12 pin and the backup light is a 6V Grain of wheat with 2 pin molex.

The wires that go in the 12 pin need to have the little connectors on them i do not have them please.

All of the above needed.

Email sent.

Last edited by Dieseler

Add Reply

Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×