Just wired up a new MTH gas station. It lights up and the car works fine coming out and going back into the station. The gas pumps don't light up. Anyone have the same problem? Would hate to have to unwire it and bring it back.
Original Post
Replies sorted oldest to newest
Did you check power going to them? If you have power, then bad bulbs
There are 5 leads to the gas station I think. 2 terminals are for the lights D&E. Not likely all the bulbs are burned out. Most likely it is not wired right. put 12 volts across terminals D and E.
http://extranet.mth-railking.c...ction/30AS14665I.pdf
Dale H
Dale, Most of his lights work. Just not the gas pumps. IF I remember correctly that is a separate harness internally to the board.
I would follow the instructions to get gas pump bulbs out and test on battery. If good, your going to have to open the unit and trace the wire to the circuit board plug. May be a simple loose connector. G
