Skip to main content

It's me again, As I have said I have DCS, also 5 separate fastrack plans. First system works fine, 2nd system has power on track, but remote shows no engine on track. I have Barry's book, Read it, but still 2nd system doesn't work. I tried hooking up my first system (which works) too the 2nd system what do I get no engine on track. Oh yes the engine (no matter how I hooked up) starts and with all the sounds, But remote shows no engine on track.I'm sorry for taking up most of this forum and Barry has tried with me, but I guess I'm just too dense. Sonny

Original Post

Replies sorted oldest to newest

Sonny...... do you mean when power is applied to track that engine powers up?
if it does then no digital signal on track.
I assume you are using the aux port to power tiu.
and that all channels set as fixed.
I don't know name of other post that Barry has been helping you so don't know what has been tried.

St Paul

Verify the Red post on the TIU output goes to the center rail.

Verify the Red LED in the TIU lights up at power on, it will blink once but since it works on the other setup it should be fine.

Do you have a break in the center rail somewhere on the loop? It needs one. Just pull the Pin or use the isolation section and take the wire loose underneath.

Last edited by Russell

Add Reply

Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×