Just acquired a TMCC F3 AA set, one powered one dummy. I went through the steps to change the engine ID, got the horn so all appeared fine.
Flipped the switches back to RUN and started it up with the new ID #. Sounds are all there but the engine won't move.
I hit the RESET button and nothing.
It runs fine in Conventional.
Thoughts??
Replies sorted oldest to newest
What are you using to run it? Legacy or TMCC?
Trainbrake? Speed limit set?
What are you using to run it? Legacy or TMCC? TMCC with my Legacy System
Trainbrake? Checked, it's off. Speed limit set? One feature I've never used, but my fat fingers have pressed multiple buttons more than once.
Select The engine. Before you do anything look in the lower right hand corner of the numeric keypad. It will say speed limit. Is it highlighted? If so push and hold until the display says speed limit cleared. You might have set the speed limit to 0.
That appears to have done the trick!
Now rolling out the speed scale gets to about 13-14 before the loco budges. Would that be normal?
If it's a Pullmor motor yes. You can set a stall speed which will get it moving quicker. The procedure should be in the manual For the engine.
From memory, with the engine stopped, push set. I think the headlight flashes. Turn the knob until the engine starts moving and then back it off until it just stops. Push set again. The engine should respond better.
Darn you're good! I went through the instructions and now the train moves before the speed graph is halfway across!
Thank You Marty! 
That's what we do! LOL. Have fun!
JeffT,
You have just witnessed 1st hand why the OGR is the best forum on the Net,
the OGR has incredible people like Marty to help everyone on the forum.
Great job Marty!
All the best
PCRR/Dave
Access to this requires an OGR Forum Supporting Membership
