problem with pm 1 powermaster

Does your PM-1 have flush red and green LED'S or little indents with the LED's exposed?

Fred

If purchased in '96, they're flush.

Mine had a 7  1/2  amp  cartridge fuse    in series  from the power supply to the power master.  It came with the power master  and was not an add on.

They are flush as Rob said.

How do reassign a channel?

Reprogram the PM-1 as TR-1, TR-2, or TR-3, etc.

ADCX Rob is correct.   Slide the run/program switch to program on the PM-1 and then press the TR button and then pick your single digit number 1-9.  Then slide the the run/pgm switch to run.

Is it possible you accidentally set the run/program switch to program when you switched it from cmd to conv?

Also, fwiw, I've had 3 PM-1's since 96 also. While I do run mostly command, I've always left them set in conventional. I just power up the Track before I select the Engine ID.  I use TR 1-3 for track control and use TR4-9 for any "lashups" in command mode.

Fred

Dale Manquen, a Forum member, repairs them.

Bill

Thanks for all your help. I took it all a part and didn't see anything goofy in there. I did mess with crystal tried to see if anything looked corded in there. Put power to the girl before i put it back together. And bingo the old girl came to life. I was wondering will the tmcc base fight with this if it is on. As last night when i was trying to fire the old girl up the base was on and was receiving a signal . Just wondering.   charlie criss

They will play along fine as long as the PM-1 is locked down in "Run" and "Conv".