RCVR board Looking for help

Just PM'd you.

The pins require a little more heat than you'd usually use on a PCB, I find I need 600F-650F to remove those cleanly.

Ray,  I have those pins/connectors.  Not really too hard.  I use my Weller temp iron (good one) with adjustable set point.  I have done them on boards similar to Lionel one.  Not too difficult.  

I can bring iron down or some arrangement.  

Mike D

@Mike Desing posted:

Ray,  I have those pins/connectors.  Not really too hard.  I use my Weller temp iron (good one) with adjustable set point.  I have done them on boards similar to Lionel one.  Not too difficult.  

I can bring iron down or some arrangement.

The one thing about the Lionel receiver board is it apparently has a an internal ground plane that soaks up heat, so a bit more heat it needed to free the pins.