Hi All: I have a Baldwin Centipede AA set - vision line. I have DCS and the CAB 1L base. I am having the hardest time programming the set so that I can run it in the TMCC environment. I will get Legacy at some point but for now it's DCS. Does anyone know the default address ID for this set. When I use 1 only the lead engine responds and trailing unit does nothing. What am I doing wrong? Mike
Replies sorted oldest to newest
does the trailing unit have a run/program switch? if so program it to 1 as well.
does the trailing unit have a run/program switch? if so program it to 1 as well.
I'm not sure that will work, unless the trailing unit has been configured to start in reverse. You may have to actually program these in an MU (lashup) after setting the ID's. I don't own these, but other powered A-A units require you to run as an MU.
I found them on the Lionel web site, Wow! they're beauties, instructions and video. I'm having a problem putting the link on here. I can't seem to high lite the thingy above were it says (inset edit link)
I checked the manual, apparently they thought of this, so if you run them both as the same ID, the trailing unit does go in the opposite direction.
Access to this requires an OGR Forum Supporting Membership
