Skip to main content

I have calibrated the controls following the instructions on page 14 of the manual.   Unfortunately, now I need to move the levers up to about 4 volts before anything happens.

Does anyone know how I can get the ignition point closer to 0 ?  I’m thinking that recalibrating it again may make it worse.  I would like it to go back to the default position.

Original Post

Add Reply

Post
This forum is sponsored by Lionel, LLC

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×