Skip to main content

I'm starting to ballast a small yard that comes off the mainline. The mainline ballast is gray limestone and I intended to use cinders in the yard. However, the color transition between the gray mainline and the black cinders is pretty abrupt. I'm considering using a dirty limestone ballast on the mainline near the yard and continuing it into the yard for a little way, but I'm curious as to what others do and am open to suggestions.

Thanks,

Jim

Original Post

I "sank" (sunk?)my Yard and siding track down to tie-top @ ground level. I did this by adding 5/16" foam core board "raise" the ground and then darkened the ballast. Really just trying to get the different, dirty look of much Yard/siding  track.

Raised Plywood temporarily replacing Yard service structures (Tower, Ash Dump etc), is where I laid my belly while working on the corner Denim Mill. Unfortunately never got to finish layout but did have power on and ran trains.

IMG_2029

Attachments

Images (1)
  • IMG_2029

Here are a few pictures of the ballasting job I did on my past layout and my current one.  

Ore stockpile start

20200429_144639Current layout has WS coarse cinders glued to a Styrofoam substrate. TABLE top is 1/2  inch MDF,  3/4 inch Styrofoam,  then a top layer of 1/4 inch Styrofoam cut out to inset the tracks.  This makes the tracks appear like they are sunk into the ground and also you use less ballast. 

DSC00211DSC00201

These 2 photos are of my previous layout.  If you live near a menards,  they sell a 50 lb bag of blasting sand. It's an abrasive  grit for stripping paint and rust from metal. I  bought a bag for $7.99 less my 11% rebate.  1 bag could cover several large layouts (a bag fills a 5 gallon bucket ). 

Attachments

Images (4)
  • Ore stockpile start
  • DSC00211
  • DSC00201
  • 20200429_144639

Add Reply

Post
OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
Link copied to your clipboard.
×
×