Skip to main content

Closed3 replies

BPC problem.

T taylorraOGR Forum Member

  I have two TPCs which provide power to the tracks thru six BPCs.  While doing some test runs , I had an engine derail and blow

a fuse on my fuse block. After fixing the problem and replacing the fuse, I continued with my testing. One of my BPCs controls blocks 13/14/15/16.

When I got to block 13, I found no power.  I tried to program ACC 13 to TPC1; I couldn't get power.  I programed block 13 to

TPC2 (track2) it worked fine.  BPC will not switch control of block 13 to track 1.  I have not tried reprogramming the BPC since the other three relay sets work fine. 

   I think that I have a BPC someplace that I replaced years ago.  I seem to remember hearing that Dale Manquin 0r someone else who posts on this board repairs  IC controls units.  If anyone has any fixes I might try before shipping the BPC off for repairs or junking it, I would be most appreciative.

Original Post

Replies sorted oldest to newest

R RalphOGR Forum Member

Hi Trainman

I put the TVS at the transformer posts, then I put TVS at each track connection - Lockon or QC for GG track. Should there be a TVS at each track output of the BPC and or on each input from the TPC to the BPC as well to protect the BPCs?

Does this hold true for the other controllers as well - ASC, OTC, AVC?

 

ralph

FM Former Member
Originally Posted by Ralph:

Hi Trainman

I put the TVS at the transformer posts, then I put TVS at each track connection - Lockon or QC for GG track. Should there be a TVS at each track output of the BPC and or on each input from the TPC to the BPC as well to protect the BPCs?

Does this hold true for the other controllers as well - ASC, OTC, AVC?

 

ralph

I would recommend putting a TVS on each input and output on all of these devices especially if they are the versions produced in China. Lou Kovatch, former owner of IC Controls and the designer of these products, told me explicitly that when they began producing these products overseas that some of the components barely met the MILSPEC.

Views: 674
Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

Membership Required

We're sorry. You must be signed in to continue. Sign In or Register
×
Are you sure you want to remove from your Block List?
×
Loading...
×
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
×
Link copied to your clipboard.
×

Access to this requires an OGR Forum Supporting Membership

OGR Forum Supporting Membership

Help support this forum with an OGR Forum Supporting Membership.
You will be able to watch the videos in the INSTRUCTIONAL VIDEO FORUM!
A one-year OGR Forum Supporting Membership is only $12 per year, so sign up now!


    OR     


Access the ALL the OGR VIDEO FORUMS AND  over 300 back issues of OGR
with a DIGITAL SUBSCRIPTION!



$12.00 per 12 Months (plus tax if applicable)
×