Cab 2 display problem

do you have version 1.52 installed?

I have the same issue, ever time I go back in and reprogram the engine number to fix it.  It seems to be happening after I control a switch then hit then hit the select button control a loco.

Bigdodgetrain,I am running the version 1.3 legacy program.

Jdevileerjr, I just tried using the switch control and then engine control to see if that would change the engine number characters. Although it did not readily appear to show a cause and effect, I will watch the switch/engine command action to see if that is the cause.  I recently installed an ASC so you may be on to something. Thanks

I wrote Lionel service about this also and hope to hear back from them this week.

Thanks, Fred 

I asked about version because I have 1.52 and sometimes I see odd things on the screen. so it is not a particular version.  will be interested to see what Lionel says.

you out there Jon Z?

will advise, Fred

That happens. Usually re-editing the engine name clears it up. I get it more when multiple remotes are running. Your remote is fine. Well as fine as anyone else's. I keep forgetting to bug Jon on it. I think it's a database corruption issue. 

I do believe I sent this in once but it's such a rare occurrence I keep forgetting to flow up. 

Ill email him tomorrow and send him a link to this page. 

Thanks Marty!

Yea my Cab.2 has been having the same problem for quite a while. Been re-editing the engine name also.

This sounds like a good use for the LSU to backup your database periodically.  Note that you can also edit stuff in the remote using the LSU.  I had an oddity where I couldn't use ID #2 for anything, when I cleared it out using the LSU, it started working normally.

Got an email back from JonZ.  They are aware of it.

I am running version 1.3 and yes, this happens from time to time. Just re-edit and your fine.

I'm using 1.5. Happens all the time to me.  I used to correct it but now I don't, got used to it I guess.