Skip to main content

Replies sorted oldest to newest

Hi Peter - thanks.

The dock was painted with Krylon Colormaxx (paint & primer). I believe the color was Satin Brown Boots, but I'll check this weekend and let you know on Monday. The stairs were left in the color they were molded in, which is like a battleship grey to mimic the look of concrete/cement stairs.  Of course, any molding flashing was cut off the parts beforehand.

I hand painted the stair risers with a small brush using Testors flat red bottle paint. Some minor paint tends to get on the treads and sides and, after drying, I went back with a little laquer thinner on a Q-tip to remove the over-paint. The Q-tip brushes up on and removes a little of the dried red riser paint and gives it a roughed-up look.

After the brown dock paint dried, I carefully filled-in the planking grooves on the top and sides with an ultra-fine point black Sharpie which gives the impression of individual planks. I then went over the top and sides with a soft, fine sanding block to remove any excess black marker and scuff up the surface a little.

Then applied two coats of Krylon matte clear on both the dock and the stairs. I then weathered the entire dock and stairs with charcoal and dark grey pastel chalks using a soft bristle brush until I was satisfied with how it looked. I then CA glued the stairs to the dock.   

Sounds like a lot, but it went pretty fast - hope this helps.

@Richie C. posted:

Hi Peter - thanks.

The dock was painted with Krylon Colormaxx (paint & primer). I believe the color was Satin Brown Boots, but I'll check this weekend and let you know on Monday. The stairs were left in the color they were molded in, which is like a battleship grey to mimic the look of concrete/cement stairs.  Of course, any molding flashing was cut off the parts beforehand.

I hand painted the stair risers with a small brush using Testors flat red bottle paint. Some minor paint tends to get on the treads and sides and, after drying, I went back with a little laquer thinner on a Q-tip to remove the over-paint. The Q-tip brushes up on and removes a little of the dried red riser paint and gives it a roughed-up look.

After the brown dock paint dried, I carefully filled-in the planking grooves on the top and sides with an ultra-fine point black Sharpie which gives the impression of individual planks. I then went over the top and sides with a soft, fine sanding block to remove any excess black marker and scuff up the surface a little.

Then applied two coats of Krylon matte clear on both the dock and the stairs. I then weathered the entire dock and stairs with charcoal and dark grey pastel chalks using a soft bristle brush until I was satisfied with how it looked. I then CA glued the stairs to the dock.   

Sounds like a lot, but it went pretty fast - hope this helps.

Thank you so much!

Peter

Thanks, guys - wish I could take credit for the boxes, but they are made by a guy on E-Crater and are very cool.

Check this thread at page 350 - from about 6-15 posts down, which has all the information about how to obtain them if you're interested.

Buy anything cool lately? | O Gauge Railroading On Line Forum (ogaugerr.com)

Peter - the dock color is indeed Krylon Satin Brown Boots !

Last edited by Richie C.

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×