Ok, I was able to set up my TMCC Conrail Diesel on my Legacy command set with the help of my Manual and the help of the forum and I am able to get the horns, lights, tower talk but it does not move at all. RPM’s go up but also no crew talk. I think I am missing something simple. I do have it set up as TMCC mode and railsounds 5. I hope I am providing enough info. If I can ask for some help, it would be appreciated!!!
Please confirm you switched back to Run mode on loco.
Yes sir. I double checked that.
Things to check:
Make sure the train brake is not all the way slid up.
Here is a link to speed limit being set accidentally and fix:
Attempt a factory reset of the locomotive.
Does it move conventionally with out Command? G
I do not think I have the train break on as I can run my legacy SD80MAC on the layout just fine. I think I will try your idea of doing a factory reset on it tonight. Thanks!
The individual engine retains the train brake setting not the system. Try addressing the engine and start it up,apply the train brake fully and then release it. The engine should move. I know Legacy engines retain the setting but don't remember for sure if the TMCC ones do.