21st Century Signal System and do not want to use insulated rail connection and would like to use a DZ 1070 sensor

I have a question

I have 3 -21st Century Signal System and do not want to use insulated rail connection and would like to use  a DZ 1070 sensor connected to.Has Anyone tried a DZ 1070 to the DIN terminal?

If I had the detector option c - but I didn't tape the optical sensor and connect the yellow wire to the Atlas DIN ( which you connect the insulated rails to ) But I think this is an input wire.
Would the
 OFF.
OPTION C  – If the optical sensor is covered with black tape, then the input
(YELLOW) wire can be used to control the sensor. Connecting the input wire
to an isolated rail will cause the sensor to change its two outputs and operate
a typical LED signal.

or

 OPTION B – The WHITE or GRAY wire can be connected to the GREEN
wire of a DZ-1008 relay module. The RED wire of the DZ-1008 should be
connected to the same power as the signal and the BLACK wire connected
to common. The sensor will then cause the relay to change when the sensor
LED turns ON and the relay will change back when the sensor LED turns
OFF.

or option  b - Can I use white or gray wire connect to DIN  to detect the block being ocuplyed

c. DIN - DIN is the detector input. It is connected to the insulated rail detector lead, (or the
detector lead from the Atlas O 2-rail detector board, (#7935 in 2-rail installations). Use green wire.

Thanks