The mailman just dropped off my transfer table that I purchased from a seller on Evilbay.   I purchased this to replace a post-war transfer table I presently own.  It is brand new.  I hooked it all up as per the instructions for conventional operation.  The table moves as it should.  However, the locomotive will not move when I press the appropriate button on the controller.  The light on the controller and the one on top of the hut will not light.  The accessory controller was pre-wired from the factory.  Although it's very difficult to see, the orange wire is connected to the clip under the bundle of wires held in place with a zip tie.  This orange wire goes to any power terminal on the transformer.  I ran a wire from the "U" terminal on my 1033 to the base of the transfer table to provide a ground.

 

Any suggestions would be greatly appreciated.    

IMG_8272IMG_8273IMG_8274IMG_8275IMG_8276IMG_8277

Dan Padova

 

"In the course of my life I have had to eat my words, and I must confess it was a wholesome diet"..........Winston Churchill

                                                                                                                                        

Attachments

Photos (6)
Original Post

Problem solved.  The table was not lined up with the track.  So no power goes to the table until everything lines up and then the lights go on.  

Dan Padova

 

"In the course of my life I have had to eat my words, and I must confess it was a wholesome diet"..........Winston Churchill

                                                                                                                                        

Add Reply

Post
OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
×