Skip to main content

Howdy 0 Scalers,

 

I've been working on a coal mine lately but took some time to goof off with this video. It is a Y6b and Class A headed coal train with a Y6a pusher. The only modeling I did on this go around was to absolutely necessarily add a yellow flag to the back of the pusher. Speed mapping for the engines worked out great.

 

It takes a few seconds for the train to come into the frame, but hang in there. I think it turned out pretty well.

 

Original Post

Replies sorted oldest to newest

Originally Posted by Hot Water:
Originally Posted by Big Jim:
Originally Posted by jaygee:

This would be east of Roanoke, with the single helper flag.

Why would you think west of Roanoke would be any different?

And, just curious, why is the flag yellow, and not a red flag on that rear coupler. 

'Cause, that is what the rule book states. However, I have never seen anything that states a "single helper flag" east of Roanoke. The use of a yellow flag/s should be universal over the entire system.

Last edited by Big Jim
Originally Posted by Big Jim:
Originally Posted by Hot Water:
Originally Posted by Big Jim:
Originally Posted by jaygee:

This would be east of Roanoke, with the single helper flag.

Why would you think west of Roanoke would be any different?

And, just curious, why is the flag yellow, and not a red flag on that rear coupler. 

'Cause, that is what the rule book states. However, I have never seen anything that states a "single helper flag" east of Roanoke. The use of a yellow flag/s should be universal over the entire system.

Thanks. That is different than what I witnessed on other "eastern railroads" during the 1950s. There always seemed to be a red flag stuck in the knuckle hole, during the daytime. Would the N&W have had illuminated marker lamps on the rear at night, or just one red lantern on the knuckle?

Thanks NYC and Gilly for the comments. Without question the train has too much power, but for the sake of mercy for most people viewing the video, I left off about 100 hoppers.

 

Jimmy and Hotwater, thanks for the discussion. I think in combination with the engines and train puts the train east of Roanoke, but not specifically anything to do with the flag. I'll admit this train was just a whim based on prototype videos of Blue Ridge, but the inspiration for my layout really comes more from points just west of Bluefield and the Class A doesn't work in as much there.

I am curious about the lantern on the back at night, though.

Last edited by christopher N&W
Originally Posted by jaygee:

West of Roanoke ..towards Christiansburg would be two yellow flags....check out Herron !

Which one? Your statement seems to read as though the Herron videos take precedence over the rule book.

Actually, according to the rule book, two yellow flags (or unlit marker lights) were to be displayed, one high on each corner of the tender, when the engine was running forward in daylight. If the engine was running backward, two yellow flags (or unlit marker lights) mounted low on each side of the pilot deck were to be displayed. 

 

The rule book is SYSTEM WIDE. For something like this, there is no provision in the rules as to what district the engine is on. Personally, I see nothing wrong with using one flag in the trailing knuckle to signify an engine pushing a train.

Last edited by Big Jim

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×