Question about voltage drop on the ZW-L

I have not seen this unless you try to bring up power like an old powermaster using the boost. Using the boost will do as you describe. Turning the knob to bring up power seems to always work for me. Did you program each unit as a ZWL on the cab2?

I programed 4 tracks with a TR address not an engine address. Not sure if that would make any difference?

I have a zw-l programmed as tracks 1-4. I address each track separately and use the cab2 to dial up the power. You do have the four handles set to maxium correct?

Are you using Command Control? check the switch on the back of the ZWL.

 

If in Conventional? Are you talking when you move the smaller handles... There is only one voltage and current meter per side and the meters default to the big handle when your hand is not on the small one. reads the small one when your hand is on it. The voltage jumping here is normal.

 

Mike does a product overview here https://www.youtube.com/watch?v=pN5S7X6y9sM

I recommend viewing this as there is so much stuff going on with the ZWL that it is ridiculous. Good luck

When it goes down does the gauge stay down if you touch the handle?

I honestly didn't try touching the handle.  I have it in command but all the handles are not cranked all the way up except for the tracks I'm running command on. I have in the mean time moved the Legacy base further away from the DCS TIU than it was.  Not sure if they would interferer with each other?  This has only happened about 3 times since I've had it this week.