Skip to main content

Hi Guys,

This latest project is one that has bothered me for sometime now. However, I'm now ready to take on the job! My fried PS 2 is on the operating table with my first question towards repair. There is a Mosfet located near U10 that is definitely bad. It's physically obvious, so you know it's bad. From looking at a good board, it appears that the part number is 352A. I checked with Mouser and they show it, but the 2 that they list have different "drain source breakdown voltages", one with a negative 30, and the other positive. Question, is this a significant spec.? Second question, what's the next likely component in this circuit that "usually" goes? I apologize, I should ask one question at a time, BUT...................

Best Regards,

Joe

Original Post

Replies sorted oldest to newest

Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×