Steel Mill Modelers SIG Annual Meet - July 12-15 - Kent, Ohio

All,

If your interest is modeling steel mills, you're in luck!

2018 Steel Mill Modelers Annual Meet (Kent, OH)

THE OHIO WORKS
July 12—14, 2018
Kent State University Hotel & Conference Center
215 S. Depeyster Street
Kent, OH 44240

More information can be found at: http://smmsig.org/

You do not have to be a member of the NMRA.

I've attended three of these meets over the past 5 years and they are a wealth of information. In fact, this year I am giving a clinic called "Modeling Weirton Steel". The meet brings together O, HO, and N scale modelers with all levels of experience. There is truly something here for everyone from the novice to the expert. You will come away with lots of cool ideas and practical ways to put steel related structures and operations on your layout.

I hope to see you there!

George

6/13/188:44 PM

❤️ 1

Original Post

Replies sorted oldest to newest

luvindemtrainsOGR Forum Member DIGITAL SUBSCRIBER

Hey George I really wish I was in Ohio right about now. I have relatives in Akron and friends in Youngstown. Kent is right there in between but I have really never had a reason to be there until now.

Dave

6/14/182:25 AM

❤️ 1

Allan MillerOGR Editor-in-Chief SUPPORTING MEMBERDIGITAL SUBSCRIBER

I don't have the space for modeling steel mill activities, but if I did--regardless of scale-- you can be darn sure I would make plans to attend this event. And since I grew up in one of the nation's largest steel industry towns (Youngstown), I am going to make an effort to attend just for the learning experience.

6/14/189:11 AM

❤️ 1

luvindemtrainsOGR Forum Member DIGITAL SUBSCRIBER

Allan,

Have you ever been to or seen the Youngstown Model Railroader's layout? Outstanding.

Dave

6/14/189:14 AM

❤️ 0

G3750OGR Forum Member SUPPORTING MEMBER

luvindemtrains posted:
Hey George I really wish I was in Ohio right about now. I have relatives in Akron and friends in Youngstown. Kent is right there in between but I have really never had a reason to be there until now.
Dave

Dave,

Sounds like a good excuse to be in Kent, doesn't it? laugh

George

6/14/189:15 AM

❤️ 0

G3750OGR Forum Member SUPPORTING MEMBER

Allan Miller posted:
I don't have the space for modeling steel mill activities, but if I did--regardless of scale-- you can be darn sure I would make plans to attend this event. And since I grew up in one of the nation's largest steel industry towns (Youngstown), I am going to make an effort to attend just for the learning experience.

Allan,

You'll find it very worthwhile. And it's only a hop, skip, and jump from you. I have a little working experience inside a steel mill, but some of the presenters have spent their careers in the steel industry. The models on display, typically HO and N scale, are nothing short of spectacular. I have learned a great deal from attending these meets, to the point where I have scrapped my 3-D backdrop version of Weirton's Open Hearth and am rebuilding it in more prototypical fashion.

Here are some low-resolution photos from the 2013 meet: