Has anyone successfully wired a Ross 3 way switch using 3 -sets of push buttons and the wiring diagram from Z Stuff's application page, which uses diodes to sync up the 3 way switch for left, center, right?
Thanks,
Bob D
Original Post
Replies sorted oldest to newest
Should only need 2 DZ1000's for that.
trainman129 posted:Should only need 2 DZ1000's for that.
I just updated my original post.
I found the problem, one of DZ1000 switches was sticking. Adjusted the spring tension and all is well. It works great!
Anyone who has a 3 way switch should try using Z-Stuff wiring diagram.
Bob D
A Ross Three way has (2) sets of moving rail points. Both sets have to be in the center through mode, before either can be switched to out. Pictured, two DZ 1000 switch motors.
Mike CT posted:A Ross Three way has (2) sets of moving rail points. Both sets have to be in the center through mode, before either can be switched to out. Pictured, two DZ 1000 switch motors.
Mike CT
With the Z-Stuff wiring diagram you do not need to have the both sets of rail points in the center before switching. You can go from right to left or left to right with one push of the button because both DZ1000's are tied together electrically using diodes.
thanks,
Bob D
That's interesting. I'll have to review that wiring.
Thank you,
Mike CT
