Skip to main content

I just purchased a used Z-4000 from a friend's Dad who had passed. Looks brand new,problem is the right throttle only shows 3.3 volts at max, put a meter on the output post and it reads 24 volts at max.Did a sweep of the right throttle and my meter shows the voltage change from 0-24 and back again. The left throttle is fine, along with the other outputs.It's just the LED is not reading right. Does anyone know why the LED readout only goes from 0-3.3 when my meter shows 0-24? Has anyone had this issue? Is it an easy fix?

Thanks,Phil

Original Post
Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×