4 level helix with an inner return track. 6-inch clearance, decent incline/decline. 21 30-inch track, 15 10-inch, 2 5-inch, 94 O72 curves and 17 O54's. I'm at the point where I need to buy wire and secure the track. This is just a test fitting to see how it all connects. The plan is to run four K-Line ABA TMCC equipped locomotives with corresponding 15-inch aluminum passenger cars, Lionel ZW-L and the Legacy #990 controller. I'm aware of the signal issues with tracks running close by or above and below. Well that's all this is.
Member AmFlyer writes in his comments on a post from April 2022 that his whole layout is covered in aluminum tape. I prefer this method over a ground plan plugged into an outlet. On top of the foil I'm using foam roadbed.
Constructive suggestions are welcomed.
