Skip to main content

I bought a new PS3 NS SD70Ace (30-4219-1) engine on Saturday, 10/20/2012.  I ran this engine all week without any problems whatsoever.  Last night I ran the speed up 75 smph.  When I attempted to reduce the speed the engine did not respond.  The engine would not respond to any DCS commands: bell, horn or couplers.  I am running the latest version of the DCS system powered with a Z1000 brick on Fixed channel 1.  The only way to stop it was E-Stop button on the remote. 

   

After reapplying power and trying the restart the engine I got the error message “Engine not on track.”   To make a long story short, the engine will not respond to commands from Fixed Channel 1 but functions correctly on Fixed Channel 2, with a second Z1000 providing track power.   I did a Factory Reset of all 3 components: engine, DCS remote and TIU but the problem continues. 

 

I read in Barry’s book that the DCS signal can turned On or Off for a given TIU channel.  Wouldn’t the TIU Factory Reset turn the DCS signals On for all channels?    Any suggestions before I send the DCS System back for in warranty repair?

Original Post

Replies sorted oldest to newest

Wouldn’t the TIU Factory Reset turn the DCS signals On for all channels?    Any suggestions before I send the DCS System back for in warranty repair?

 
        
 
 A factory tiu reset should however you can also use  Menu/System /DCS set up/AON   (all channels on)
 
 You also may have blown a fuse on fixed 1...  I'm just not sure whether a blown fuse on  Fixed 1 will allow the tiu to turn on,  You need fixed 1 powered or an AUX power suppply to turn on the tiu. The fuse is worth checking out , might save you sending the unit for repair, Funny thing about the fuses, they're on the Ground side, (i know wrong term) rather than the hot side.
 
After a E-stop, both tiu and remote must be shut down and restarted, don't forget about the aux power supply if using one. Good luck.
Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×