I am unable to turn on the track power via the 990 Cab2 controller. The system is set up
with the 990 base/controller, a 180 V brick and a legacy power master. The last time
I ran the system (2 weeks ago) it ran fine. So now I turn on the brick and the 990, then either turn
the wheel or hit boost and no track power. Power master light is on but I do not see the blinking
red light when I make a command with the cab2 controller, i.e. no signal from controller to power master.
Cab2 controller turns on normally appears to function normally, also lights on 994 base all seem to be on and small
red light in lower right corner flashes when controller is operated. What do you think? Mike
