Skip to main content

Replies sorted oldest to newest

Well, just this morning I had one of these in my hand with the intent to confirm fit, and now I misplaced it, CRS creeping in, but I am pretty sure that the 2 pin connector that goes on most cordless phones battery is the same size as the 2 pin jack in the MTH Loco if you want to roll your own outboard charger.  They are also good to make a BCR  that will plug into the 2 pin plug in the line to the circuit board.  I think I remember correctly that the battery connector is  female, following protocol, it should be ( a connector that receives power male, connector that provides power, female).  Of course you have to still have to have a landline with a cordless phone hooked to it and a dead battery to rob the connector from.

Add Reply

Post
This forum is sponsored by MTH Electric Trains

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×