Skip to main content

Replies sorted oldest to newest

Originally Posted by drelo:

Do you run command or conventional?  If running conventional, I would go with a Williams by Bachmann RS-3.

I'll be using Fastrack ,running conventional. But do have Lionel Trainmaster Command system. At present laying tracks which will be incorporated into layout later. At present, wish to setup for a switching operation. Thanks

If you're set on PRR, I've seen some nice K-Line A-5 0-4-0 switchers with and without TMCC on the aftermarket. 

 

There are NW and SW switchers available in PRR.

 

If you're running traditional (as opposed to scale) as I do, I'm planning my next conventional switcher to be an RMT S-4.  It's a bit smaller than the NWs and SWs which seems like a better match for traditional-sized runners like me.  The NWs and SWs look OK, but they're pretty close to 1/48 scale.

Whatever you choose for a switcher, make sure it has these attributes:

1. An electric operating coupler on each end;

2. Good slow speed operation;

3. Spacing of electrical pickups so it will not stall on your switches. Diesel switchers run very well, but they are short, so their electrical pickups are relatively closely spaced. Steam locomotives with tenders typically have better spacing of electrical pickups.

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×