DCS is running and working great. I have two TMCC engines loaded into the remote and they work great, except: If they are both on the track at the same time. If I select one, they both move at the same time. If I select the other one, it moves when it should and the other stays put. Have I programmed something wrong? They have different numbers assigned in the remote, but they are both using factory settings for TMCC of 1. Any help would be appreciated.
Thank you, Terry
Replies sorted oldest to newest
You must give two TMCC engines different id's. you can leave one of them as #1
but the other must be assigned a different number. I usually
use the last two numbers of the locomotive number. You can use any number you
like up to #99.
Al
You can use any number you like up to #99.
Not exactly. Numbers 91-99 are reserved for TMCC lashups and cannot be used by individual TMCC/Legacy engines.
Thanks Al and Barry! Took minutes, realized I could do it with the cab 1 remote or DCS remote per Barry's book, and was up in running great in no time! Thank you! Terry
Access to this requires an OGR Forum Supporting Membership
