Skip to main content

I have an Atlas O SF RSD15 engine that dies on any switch. Apparently the front pic-up somehow does not transmit power to the motors since when the rear pick-up reaches the "dead" spot on the switch and the engine stops. I wired the rear and front pick-ups to each other just in case one isn't transmitting, bit still the stall. I'm baffled.Can anyone unbaffle me?

Original Post

Replies sorted oldest to newest

I had this problem and found that the switch was screwed down too tight, thereby distorting its integrity by just enough to stall an engine in the middle of the switch.  I loosened up the screws on that switch and the engine ran right through.  Check this on your switch.   I've read that some folks don't screw their switches down at all and they operate just fine.   

Last edited by Patrick1544

Patrick makes a valid point about "too tight" when screwing-down track or a switch. For efficiency, many hobbyists use a power screwdriver to quickly and effortlessly install track screws. That tool can easily apply too many turns of a screw. Solution -- use the tool to set a screw in place, but gently hand-turn the screw home.

I'm one of those who doesn't screw down switches - in order to avoid binding the moving swivel rail of the switch. I'll place screws in the track leading to a switch, but STOP at five inches away.

Mike  (ritrainguy)

 

Well, thanks for all the technical advice. I followed procedures recommended above and discovered the problem. The wire feeding from the front pick-up was compromised just above the attachment to the pick-up screw( hidden by insulation). Replaced the wire connection and all is in working order. Now I can run one of my all time favorites - the SF "alligator" RSD15 by Atlas O - black and silver with its menacing look that I love.

Thanks again for the advice. This forum rocks!

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×