When I moved the railking crossing gate two wires came loose from the circuit board. the white and yellow. I am not sure at which positions they go to on the small circuit board. Has anyone any idea of which positions those two wire go to.
Thanks Marty
Replies sorted oldest to newest
I found this pic from an earlier OGR thread. It doesn't have the exact info you're asking but if you look at the white arrow, the wires going to the board at your locations 1,2,3,4 appear to be Black, Red, Yellow, unshown.
So by inference, I'd say 3=YLW, 4=WHT.
The pic is from a teardown where I drew out the electrical schematic. The WHT and YLW wires control up and down. So if you get them backwards it would just mean the gates go down when they should go up and vise versa. That is, you'd just have to swap the wires.
Stan,
thanks for the reply will give it a shot
Marty
Access to this requires an OGR Forum Supporting Membership
