Skip to main content

Closed2 replies

MTH Proto 3.0 Diesel Sound Cuts In and Out

P PRREnolaOGR Forum Member

Hello,  I recently (last week) purchased a "new" MTH D&RGW Heritage SD70ACe Diesel with Proto 3.0. I'm having a problem with the sound "cutting out".  It goes thru the "start-up" sequence ok...runs around the Layout 2-3 times....and then the sound "drops out"...No prime mover sound...no horn, no bell, no ditch lights etc. It continues to run...and will change direction and increase and decrease speed...but "no sound"...and then, sometimes the sound comes back. I don't have this problem with any other MTH Proto 2 Locomotive I operate.  If I shut it down, when I do the "start-up" sequence...it has sound again....and then 2-3 laps later....no sound..?? Any help is appreciated....I'm hoping it's something simple and I don't have to send it back....BTW...Do the Proto 3.0 Locos have "Batteries"...It almost seems like a dead battery....but I can't find anywhere in the operating instructions where it shows how to "charge" a battery...?  So, I'm assuming it doesn't have a battery...?   Thanks

Original Post

Replies sorted oldest to newest

Barry BroskowitzBarry BroskowitzOGR Forum Member MEMORIALIZED MEMBER

It sounds as if Clickity-Clack may be turned on. Turn it off by pressing:

Menu/Sound/Clickity-Clack and press the OFF soft key.

 

This and a whole lot more is all in "The DCS O Gauge Companion 2nd Edition", now available for purchase as an eBook or a printed book from MTH's web store site! Click on the link below to go to MTH's web page for the book!

 
 
P PRREnolaOGR Forum Member

Hello Barry,  Thanks for taking the time to respond to my query about the "drop out" of sounds on the Proto 3.0 D&RGW SD70ACe.  I'm not sure what my Son might have "turned on or off"  while testing the new 3.0 Diesel, but it must have been something. Shutting off the "clickety-clack" didn't restore the diesel sounds but doing a "Re-Set" on the DCS Remote "did" restore the Diesel to it's original "default".??  At any rate doing the "reset" corrected the problem.  Thank you for putting me on the right path. The Diesel seems to be working fine now.

Views: 782
Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

Membership Required

We're sorry. You must be signed in to continue. Sign In or Register
×
Are you sure you want to remove from your Block List?
×
Loading...
×
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
×
Link copied to your clipboard.
×

Access to this requires an OGR Forum Supporting Membership

OGR Forum Supporting Membership

Help support this forum with an OGR Forum Supporting Membership.
You will be able to watch the videos in the INSTRUCTIONAL VIDEO FORUM!
A one-year OGR Forum Supporting Membership is only $12 per year, so sign up now!


    OR     


Access the ALL the OGR VIDEO FORUMS AND  over 300 back issues of OGR
with a DIGITAL SUBSCRIPTION!



$12.00 per 12 Months (plus tax if applicable)
×