Skip to main content

Hello I am setting up a small layout (12 by 12) to test out DCS. I have a revision G TIU (There is no label on bottom) and wanted to know if it was OK to tie all of the black terminals together. I metered 0 ohms from input side to output side on each channel but not from 1 channel to another. Thanks for any suggestions on this.

Original Post
Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×